Fabrication Of CT Scanning Appliance Using An Existing Denture
Fabrication Of CT Scanning Appliance Using An
Existing Denture
1. CLINICIAN OR LABORATORY
Using
a denture duplication flask, mix duplication material and place it into
one side of the flask. Place the patient’s existing denture into the
material with the tissue side down. Allow the duplication material to
set per the manufacturer’s instructions. Apply a separator to the
surface. Mix duplication material and place it into the other side of
the flask and close the flask over the denture. Allow the duplication
material to set. Separate the flask and remove the denture.
|
|
2. Create a mix of 30% barium sulfate and cold cure tooth shade acrylic resin. Pour the mixture into the tooth areas only. Allow the acrylic to set per the manufacturer’s instructions. Create a mix of 10% barium sulfate and cold cure tooth shade acrylic resin. Pour the mixture into the flask. Close the flask tightly. Allow the acrylic to set. |
|
|
3. Remove the CT scanning appliance from the duplication flask, finish and polish. |
|
|
4. CLINICIAN |
